LOADSPACE COVER [G2789073]

WARNING:

Never place objects on top of the loadspace cover. During an accident or sudden maneuver, loose objects could cause serious injury or death.

The powered loadspace cover controls are located on the right hand side of the loadspace trim.

  1. Press briefly to retract the loadspace cover to its folded position.
  2. Press briefly to deploy the loadspace cover to its extended position.
  3. Auto mode. The light indicates the status of the loadspace cover system. Press to switch between different modes:
    1. White: Auto mode ON.
    2. Orange: Auto mode is OFF.
    3. Flashing: Fault.

With auto mode on, the loadspace cover moves to its retracted position when the tailgate opens. When the tailgate is closed, the loadspace cover move to its extended position. With auto mode off, the loadspace cover remains in its current position. See OPENING AND CLOSING THE POWERED TAILGATE.

CAUTION:

Ensure the front locator pegs are fully engaged in the forward position when fitting the roller blind cover. Failure to engage the locator pegs may result in an unsecured loadspace cover and/or unwanted noise.

NOTE:

The powered loadspace cover will stop if it detects an obstruction. If the loadspace cover does not re-initialize after the obstruction is removed, press and hold the AUTO (3) button for 6 seconds. If the loadspace cover does not re-initialize and there is no obstruction, seek assistance from a retailer or authorized repairer.

Manual loadspace cover
WARNING:

Do not store the manual loadspace cover loose in the vehicle. During an accident or sudden maneuver, loose objects can cause serious injury or death.

The manual loadspace cover fits into slots located on the sides of the loadspace. To fold the loadspace cover:

  1. Push firmly down and forward. Then, push upward on the underside of the loadspace cover handle.
  2. Fold the loadspace cover forward.

To remove the loadspace cover:

  1. Pull the whole assembly rearward.
  2. Disconnect the locating pins. Remove the loadspace cover and store safely.
NOTE:

Replacement parts for the loadspace cover, including locator sleeves and shuttle nozzles, are available through retailers/authorized repairers.

To access the loadspace from inside the vehicle: Push firmly down on the furthest edge of the cover while pulling it toward the rear seats. The cover folds, allowing access to the loadspace area.

CAUTION:

Ensure the front locator pegs are fully engaged in the forward position when fitting the roller blind cover. Failure to engage the locator pegs may result in an unsecured loadspace cover and/or unwanted noise.

Spare parts for the roller blind cover, such as the nozzle shown above, are available via retailers/authorized repairers.

7-seat roller cover

7-seat models are available with a roller blind cover as illustrated. Pull the handle (1) to extend the roller blind cover rearwards. Engage the pegs in the loadspace side trim (2) and (3) to retain the extended cover. Release the pegs by pulling rearwards and upwards. The cover retracts back into the casing.

CAUTION:

Ensure the front locator pegs are fully engaged in the forward position when fitting the roller blind cover. Failure to engage the locator pegs may result in an unsecured loadspace cover and/or unwanted noise.